4 Reasons Why a Holset HX35 HX40 Bearing Housing Need To Be Replaced:

• Rusted So Bad that the Turbine Clamps No Longer Retain the Bearing Housing To the Turbine Housing
• Oil Contamination Which Leads to Scaring and
• Excessive Shaft Play, Rear Seal Area Will No Longer Allow the Seal To Stay Compressed
• The Compressor Housing No Longer Seals And You Need an O-ring

67mm HX40 Bearing Housing Machined for O-ring

If You Need to Purchase a Bearing Housing, You can Buy From Our Ebay Store in the Link Below, But You Need to Leave a Note In the Purchase Order of the Exducer Size of the Compressor Wheel.